Rooting Your MotoACTV On Linux

=======================Things *NOT* to do with your MotoACTV (Read First!)==============

  1. NEVER EVER EVER EVER issue the adb/fastboot commands "adb reboot-bootloader" or "fastboot reboot-bootloader", even though it works on other devices. This will often put your device into a fastboot loop that is NEARLY IMPOSSIBLE to get out of.The way to exit this loop is:
    A) With the device unplugged, hold START, POWER, VOL UP, VOL DOWN together for 10 seconds at least. You should see the screen flicker on and off twice.
    B) Plug in the USB cable to turn device on.
    C) You should boot back to rom, if not, do it again. It's touchy.
    Use the following command to exit the fastboot loop:
    fastboot oem fb_mode_clear
    after this, you may reboot normally. (Thanks CEnnis91 and [mbm]!)
  2. Never begin flashing ANYTHING unless your device has 60% charge or greater. Try for 100% full charge every time.

Becareful, each rom have a special way to root it.
Check on them page before following this instructions

0 Download your new rom and extract it
You must have boot.img , system.img

I Install fasboot on your computer

If you are on Archlinux don't for forget to add udev rules

II Check the battery of your MotoACTV .

It needs to be fully charged.

III Reboot your MotoACTV into fastboot mode

With the MotoACTV turned off, press and hold "volume down" key and "power" key until the display lights up, release both keys.

IV Plug your cable in

Plug the usb cable to the MotoACTV and the computer

V Go to your extracted rom's folder
<span style="text-align: left;">fastboot -w
fastboot flash boot boot.img
fastboot flash system system.img
fastboot flash preinstall preinstall.img
fastboot -w
fastboot reboot</span>

VI Follow rom's specific rules